Hex bar to Berg Linkage on Dellorto's

This section is for general discussion related to VWs, and air-cooled bits ‘n bats.
Post Reply
User avatar

Topic Author
BusBoyT2
Registered user
Posts: 909
Joined: Fri May 02, 2003 12:43 pm
Location: Leigh-on-Sea
Contact:

Hex bar to Berg Linkage on Dellorto's

Post by BusBoyT2 » Thu May 22, 2008 6:20 am

I am changing from my hex bar set up to a new Berg fan mounted linkage. My Dellorto (40) carbs have a bottom plate which has the support for the hex bar does anyone know where I can get just a standard plate without the bit for the hex bar as I will no longer need it and it doesn't look that nice once changed to the Berg linkage.

Cheers


flatbeat
SSVC Member
SSVC Member
Posts: 1894
Joined: Thu Oct 04, 2007 4:06 pm
Location: Gloucester

Post by flatbeat » Thu May 22, 2008 10:50 am

Eurocarb ltd (0118 943 1180)might have one, they're near Reading and have been helpful in the past.
Packed a few belongings and headed out to Pirates Cove. In my buddy’s old grey Kombi we rolled until the gas got low.....

1965 11 Window aka 'Rustina'.
1961 Beetle.

User avatar

fastwheels
SSVC Member
SSVC Member
Posts: 426
Joined: Sat May 19, 2007 9:55 am
Location: south yorkshire

Post by fastwheels » Thu May 22, 2008 8:47 pm

Just swap them from right to left so the bracket for the x-bar is at the back they will be hiden by the air fillter :roll:
UK SBS#68

58 kombi M529
57 oval ragtop
T5 panel van

http://www.facebook.com/FastwheelsVw
http://www.Fastwheels-vw.co.uk

User avatar

Topic Author
BusBoyT2
Registered user
Posts: 909
Joined: Fri May 02, 2003 12:43 pm
Location: Leigh-on-Sea
Contact:

Post by BusBoyT2 » Thu May 22, 2008 10:09 pm

Yep, that was going to be my fall back just thought i'd see if I could get a standard bottom plate before I go that route so I could sell on the linkage with the brackets.

Cheers

Post Reply