The Split Screen Van Club

philsparks wrote: ↑

Sat Feb 02, 2019 10:33 am

Is that pictures of your standard chassis underside blast and paint?

Sent from my SM-J320FN using Tapatalk

Hi

Yes this is the basic standard we achieve on chassis’s (once blasted and welded) but if needed we can detail the chassis more and give it a higher gloss finish.

vwbuzzers wrote: ↑

Thu Jan 31, 2019 9:40 pm

Would love to get my bus done at yours the work looks spot on.

Buzzers

Thanks very much!

Petes 67 engine bay.

67 Pete’s chassis finished.

67 Pete paint.

Couple of panels arrive, welding in tomorrow

Batch one (of many) powder coated in satin black ready for fitment next week, awaiting all the little bearings, seals, mounts etc and the red 9 setup then we can get the bus rolling!

After a long delay we finally have the missing panel, so now the new genuine fuel tank panel is getting a light blast and will be installed on the bus. Another issue we found was that the cargo door gutter area had bent, in several areas due to rot. Now we have removed the gutter and started to repl...

Full set of genuine tinware ready for blasting and powder coating.

The rear corner damaged has effected the drivers long panel just at the very end just below the bottom vent so that’s coming out and the wheel arch straightened out, rear corners off and battery tray out. New long panel section found and cut ready and we are almost ready to weld up the rear end.

markp wrote: ↑

Fri Jan 25, 2019 10:58 pm

wow

awesome .....


Why s it green in some pics ?

Marl p

The shell has been blasted and we have colour matched the primer to the original paint code Irish green, just makes it more interesting and colour instead of grey..

Making the new brake lines.

Postman has been.

Lots of goodies to start bolting on.

Chassis photos

Before we fit the loom we will be rewrapping it in cloth tape to give a more vintage look.

Thank you Volksgoods again for the loom.