Hi I'm in the middle of making my interpretation of a Devon
Interior I have sourced loads of pics from here and Bobleys plans that he drew
But can't find any details for the tall bulkhead cupboard could some one take a few
Measurements of it for me please I am after the width ,overall height , depth ,
how much the
Top half angles back from vertical and the height of the bottom front panel
To where it starts to angle back oh and the width of the oak that makes up the door frame
Work . Any info would be much appreciated
Thanks
Martin

top half doesnt angle back from vertival does it ??

(i`m too lazy to actually open the front door and walk to the garage)
i think its vertical all the way up

Yes the tall one does that sits behind the drivers seat on
A rhd or passengers seat on a lhd go on Maddison motivate your
Self pop out and have a look oh and take your tape measure

motivated now i`ve had some coffeee

width - 22" at the bottom 20" at the top (as it curves in on the cargo door side)

Height - 38" to the bottom of the alloy tim

Depth - 9" at the bottom (probably a bit deeper, i only measured to the wooden batton between the cupboard and cargo door - so probaby 9.5 or 10") 7.5" at the top (but the back is set furthe back than lower down as it hangs over the divide - if that makes sence)

the top of the cupboard is set back 3.5" from the bottom , so cant give the angle in degrees, but that measurement should help

Thanks Maddison those measurements are
Perfect, that will make it so much easier as there's only
So much you can get from a pic thanks again for you time
Cheers Martin

Sorry Maddison could you give me the height
Of the bottom panel to where it starts to slope backwards
Sorry to be a pain

17"

....and the top panel is so tight against the B post on installation that the trim does not go all the way round.

Nice one thanks guys ! Maddison I owe you one 

Before you start making door cupboard for crockery and wash bowl flap, you'll need to check out the way the doors open, the position of the handles etc. Because you will have to modify the position of the units because it is LHD. kent57,s thread identified that this was a problem. He discovered this after he had made the units....
Check out his thread and pictures of what others have done with LHD..I have a few LHD pics....

Thanks Nexus 7 I will check that out if you
Have any pics that would be very helpful
Cheers Martin